Rexel SmartCut A425 Manual De Instrucciones página 5

Cutting mat
Cutting mat has four cutting positions (2 each side). When
blade does not cut cleanly, either rotate the mat or flip over
to new cutting surface. When mat has been used completely
on all four positions, replace it (D).
Accessories
Cutting Mats: A425 - 2 cutting mats, Part number: 2101986
A445 - 2 cutting mats, Part number: 2101988
Replacement Multi blade disc: Part number: 2101987
Service
Do not attempt to service or repair the unit yourself. If your
trimmer is under warranty return it to the point of purchase
for replacement or repair. If your trimmer is no longer
under the point of purchase return period and requires
replacement or repair, please contact your supplier for
further assistance.
Guarantee
Operation of this machine is guaranteed for two years
from date of purchase, subject to normal use. Within the
guarantee period, Rexel will at its own discretion either
repair or replace the defective machine free of charge.
Defects due to misuse or use for inappropriate purposes are
not covered under the guarantee. Proof of date of purchase
Register this product online at www.rexeleurope.com
Cutting blade replacement
Cutting Blade Removal
Remove the knurled screws (E1) and remove the rotary
1
blade housing (E2); the rotary blade knob (E3); and
spring (E4).
Take away the multi-blade assembly (E6) by unscrewing
2
the center Screw (Philips) (E5).
CAUTION: NEVER TOUCH EDGE OF CUTTING
BLADE DIRECTLY
Reassemble with new multi-blade assembly in reverse
3
order. Use replacement part #2101987 A425 Multi-blade
disk.
To Reassemble Cutter Head
Position the multi-blade assembly (E6) onto the housing
1
of the multi-blade cutting head (E7) and ensure that the
keying post (small rectangular protrusion) (F1) is in the
12 o'clock position and that the 4 longer posts are facing
outward (F2).
CAUTION: NEVER TOUCH EDGE OF CUTTING
BLADE DIRECTLY
Install screw (E5) into center of the multi-blade assembly
2
(E6) with philips head screwdriver (do not over tighten).
Place the spring (E4) into the center recess of the rotary
3
blade Knob (E3).
Place rotary blade knob and spring (E3 & E4) onto blade
4
assembly (E6). Align key (F3) with F2 & F1 in 12 o'clock
position (most upright).
Carefully slide the housing (E2) onto the knob (E3),
5
install and tighten the two knurled screws (E1).
will be required. Repairs or alterations made by persons not
authorised by Rexel will invalidate the guarantee. It is our
aim to ensure that our products perform to the specifications
stated. This guarantee does not affect the legal rights
which consumers have under applicable national legislation
governing the sale of goods.
G
5