Warmup 4iE Serie Manua De Instrucciones página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Mounting Thermostat
1.
Push excess wire back through the wall box and
insert thermostat back module into wall box.
2.
Put fixing screws through mounting holes and
tighten.
3.
Ensure that thermostat is straight before tightening
completely.
4.
Replace thermostat front housing;
i) align and sit front housing on to hinges,
ii) push lower half of front housing until a
'click' is heard.
5.
Ensure front housing is securely fixed.
6.
IMPORTANT: Tighten both retaining screws
7
4
OB
33
Powering Up
You can now power up the thermostat and begin the
programming process. An easy to follow menu will
guide you through the rest. If you want to turn on / off
the thermostat and heating system then hold down the
recessed button on the bottom of the stat for 3 seconds
Error Messages
Your thermostat can give you two error indications:
1.
"er1": This will occur if no floor sensor is detected
2.
"er2": This will occur if the floor sensor has a short
circuit

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

4ie-01-xx-014ie-01-xx-02

Tabla de contenido