Eneral Notes On Safety; U - Purposes For Which It Is Intended; Se Of The Machine For; I Ncorrect Use - SUHNER ABRASIVE LWB 4 Manual De Instrucciones

1. n
1.1 g

enerAl notes on sAfety

This operation manual is applicable for the machine LWB
4.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The machine is designed for grinding, matting, structur-
ing, brushing, polishing and smoothing of metal, wood,
plastic and the like.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Otto Suhner AG, Industriestrasse 10, CH-5242 Lupfig,
hereby declares under sole responsibility that the product
with the serial or batch no. (see reverse side) complies
with the requirements under the Directive 2006/42/EG.
Applied standards: EN ISO 12100, EN ISO 11148. Docu-
ment Agent: M. Voyame. CH-Lupfig, 12/2017
M. Voyame/Division manager
2. c
2.1 P

rior to tAKing the mAchine into serVice

Use oiled compressed air (see also air quality un-
der section 2.3).
Observe national regulations.
2.2 t
AKing the mAchine into serVice
2.2.1 t
urn on
Tilt lock forward and press lever on plastic sleeve
14
S
oteS on afety
ommISSIonIng
2.2.2 t
urn off
Releasing the lever switches the machine OFF.
2.3 r

Ating dAtA

Pressure
Power output
Air consumption full load
Air consumption at idling
Setting oiler idle
No load speed
Sound pressure level ISO 15744
Vibration EN ISO 28927-3
Air quality ISO 8573-1
Lenght
Weight hand tool
2.4 o

PerAting conditions

Temperature range during operation: 0 to +40°C
Relative air humidity: 95% at +10°C not condensed
3. h
andlIng
3.1 t
ools
Use only clean tools!
3.1.1 c /
hAnging fitting the tool
Hold spindle by wrench flats with open end wrench and
release/tighten down collet chuck with open end wrench.
Perform a trial run a minimum over a period of 30 seconds
without load.
3.2 w
orKing instructions
On failure of the compressed air release the valve lever!
To achieve an optimum grinding result, move grinding
wheel uniformly back and forth with light pressure.
Excessive pressure lessens the working capability of the
machine, as well as the life of the grinding wheel.
max. 6.3bar
250W
3
0.52 m /min
3
0.2 m /min
1-2 drops/min
-1
4'500 min
69.7dB(A), K=3dB(A)
1.87m/s2, K=1.46m/s2
3/4/4
208mm
0.490kg
/o
peratIon