Insert The Battery - Panasonic EYFPA1J Manual De Instrucciones

Insert the battery

1. Pull out the battery holder.
1 Push in on the fastener as indicated by the
arrow.
2 Pull out the holder.
. Insert the battery and push the holder
back in.
NOTE:
• If the tool does not respond to the wire-
less remote control even when the
remote control is operated close to
the tool, the battery (CR0) is dead.
Replace it with a fresh battery.
• The included battery is provided for
sample use and may not last as long as
commercially available batteries.
Wireless remote control range
[Fig.16]
The remote control should be operated within
approximately 0 cm and approximately 60°
vertically and horizontally of the perpendicular
relative to the infrared receiver on the tool.
• Under the following circumstances, you may
not be able to operate the tool, even within
this range.
- If there is an object between the remote
control's transmitter and the tool's receiver.
- Use outdoors or in other environments
where the remote control receiver is
exposed to a strong light source, or when
the remote control transmitter or receiver is
dirty may cause the tool to fail to respond,
even when the remote control is used within
the operating range.
[Main Unit]
CAUTION:
If a tool holder is used with the
Panasonic EYF series assembly tools,
make sure the tool's trigger switch
doesn't hit the tool holder. It may run
the tool accidentally and result in battery
failure by unexpected battery discharge.
[Fig.17]
CAUTION:
When storing or carrying the tool, set
the Forward/Reverse lever to the center
position (switch lock).
NOTE:
Exercise caution to ensure no objects
come into contact with the tool's trigger
switch.
If an object comes into contact with
the tool's trigger switch, even while the
Forward/Reverse lever is in the center
position (locked), a small amount of
electric current may continue flowing,
which may cause an excessive dis-
charge from the battery pack and sub-
sequent battery pack failure.
Switch and Forward/Reverse
Lever Operation
[Fig.18]
1. Push the lever for forward or reverse rota-
tion. Check the direction of the lever before
using.
. Depress the trigger switch slightly to start
the tool slowly.
3. Speed will increase by pressing the trig-
ger. The tool stops working immediately by
releasing the trigger.
4. When done with an application, lock the
switch by centering the lever.
NOTE:
The more the speed control trigger is
pulled, the higher the speed becomes.
CAUTION:
When operating the tool by pulling the
trigger, there may be a momentary lag
before rotation starts. This does not sig-
nal a malfunction.
* This lag occurs as the tool's circuitry
starts up when the trigger is pulled for
the first time after installing a battery
pack or after the tool has not been
used for at least 1 minute (or at least 
minutes when the LED is on). Rotation
will start without any lag during sec-
ond and subsequent operations.
- 11 -
EN EN