Panasonic EYFPA1J Manual De Instrucciones página 20

VII
.
ACCESSORIES
EN EN
Charger
EY0L
Battery pack for EYFPA1
EYFB60
Battery pack for EYFNA1
EYFB0
Remote control
EYFA31
Protector for tool EYFPA1
• EYFA07-A (Blue)
• EYFA07-Y (Yellow)
• EYFA07-H (Gray)
• EYFA07-G (Green)
Protector for tool EYFNA1
• EYFA0-A (Blue)
• EYFA0-Y (Yellow)
• EYFA0-H (Gray)
• EYFA0-G (Green)
Federal Communications Commission Interference
Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 1 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assume continued compliance, install and use in accordance with provided
instructions. Use only the battery pack specified in the instructions. Any changes or modifications
not expressly approved by the party responsible for compliance could void the user's authority to
operate this equipment.
This device complies with Part 1 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and () this device must accept any
interference received, including interference that may cause undesired operation.
FCC ID: O4O­EYFPA
Protector for battery EYFB60
EYFA0-H
Protector for battery EYFB0
EYFA10-H
Assembly Qualifier
• EYFRZ01
• EYFR0
Tool hanger
EYFA41
CAUTION:
• Tool hanger is for balancer use only.
Excessive force or impact might break it
and the main unit might fall off.
• Use only applicable battery pack;
EYFB60 for EYFPA1
EYFB0 for EYFNA1
IC: 8507A­EYFPA
- 0 -