Air Filter - Paslode CR175C Manual De Instrucciones

Servicing

Air Filter

Open the grille by pressing slightly above the adapter and
pivoting the cover open. The air filter simply lifts out.
Tap the filter GENTLY to remove any dust. Check and clean
the air filter every two days. Soap and water restores the
filter to a "like new" condition.
End-of-Workday Routine
These simple steps are based on maintaining the safety
and operational efficiency of the Cordless Roofing Nailer.
Before you leave the work site:
1. Remove battery and fuel cell and store in the tool
case. Always use the Cordless Roofing Nailer case
for transporting and storing the tool.
2. Dispose of all empty fuel cartridges. Remember to
dispose of these cartridges where they will not be
crushed, punctured, burned or found by children.
When you get home:
1. Place the battery in its charger if it needs charging as
indicated by the red charge light on the handle.
2. Wipe your Cordless Roofing Nailer with a clean, soft
cloth.
3. Remove and clean the filter every two days.
4. Check work contacting element and the nail feed area to
ensure it is operating freely. Remove any tar build-up
with Paslode Cordless Tool Cleaner.
GRILLE
GRILLE
Paslode Cordless Tool Accessories
A variety of accessories are available for the Paslode
Cordless Roofing Nailer:
FILTER
FILTER
Battery - Part No. 404717
Clear Safety Glasses - Part No. 401382
Paslode Cordless Lubricating Oil - Part No. 401482
CAP CAP
Battery Charger Kit - Part No. 900200
Automotive Adapter - Part No. 900507
Paslode Backpack tool Case - Part No. 904592
Paslode Cordless Tool Cleaner - Part No. 219348
Tool Safety Tether - Part No. 904548
Contact your Paslode
information.
Tools
A 5/32 Hex Wrench (Part No. 401331), 9/64 Hex Wrench
(Part No. 900736), and a 3/16 Hex Wrench ( Part No.50144)
are provided with each cordless roofing nailer.
representative for additional
®
15