Troubleshooting - RIDGID 122 Manual De Instrucciones

Troubleshooting

SYMPTOM
Excessive vibration dur-
ing operation.
Machine not cutting
tubes properly.
Machine stalls while cut-
ting.
Excessive tube burrs or
end deformation.
POSSIBLE REASONS
Cutting bent tubes on machine.
Long tubes not properly supported.
Machine not properly mounted.
Worn blades or cutter wheel.
Use on incorrect tube size or material.
Applying excessive force on the handle while cutting.
Worn or damaged cutter wheel.
Applying excessive force on the handle while cut-
ting.
122/122XL Copper Cutting and Prep Machines
Do not cut visibly bent tubes on machine. Use
hand cutter, or straighten tubes before cutting.
Support longer tubes with pipe stands.
Properly mount the machine on flat surface, bolt
with the mounting bolts.
Replace worn blades or cutter wheel.
Use on correct type of tubes (see Specifications) .
Gently apply force on the handle.
Replace cutter wheel.
Gently apply force on the handle.
SOLUTION
13