Palmgren 81112 Manual De Operación página 8

Palmgren Operating Manual & Parts List
MAINTENANCE (CONTINUED)
• Close the cabinet door and secure it with the knob.
• Replace aluminum disc and secure it by tightening the set
screw.
• Replace dust collection port and disc cover plate and secure it
with bolts.
• Replace disc table onto the disc guard and secure it using the
two handles.
CLEANING
Keep machine and workshop clean. Do not allow sawdust to accu-
mulate on the tool. Keep the drums clean. Dirt on drums will cause
poor tracking and belt slippage. Operate tool with dust collector to
keep dust from accumulating.
WARNING:
After sanding wood or nonmetallic material, always
clean dust collector and guards of sawdust before grinding metal.
Sparks could ignite debris and cause a fire.
Be certain motor is kept clean and is frequently vacuumed free of
dust.
Use soap and water to clean painted parts, rubber parts and plastic
guards.
LUBRICATION
The shielded ball bearings in this tool are permanently lubricated
at the factory. They require no further lubrication.
• When operation seems stiff, a light coat of paste wax applied to
the belt and disc tables will make it easier to feed the work
while finishing.
• Do not apply wax to the belt platen. Belt could pick up wax and
deposit it on the drums causing belt to slip.
KEEP TOOL IN REPAIR
• If power cord is worn, cut, or damaged in any way, have it
replaced immediately.
• Replace worn abrasives when needed.
• Replace any damaged or missing parts. Use parts list to order
parts.
Any attempt to repair motor may create a hazard unless repair is
done by a qualified service technician.
8
81112