To Connect The Battery To The Product; To Stop The Product; To Start The Product - Husqvarna 550iBTX Manual Del Usuario

3. Follow the instruction steps in the Husqvarna
Connect app to connect and register the product.
Note: Husqvarna Connect app is not available for
download in all markets.

To connect the battery to the product

WARNING:
Husqvarna original batteries in the product.
1. Make sure that the battery is fully charged.
2. Pull out the locking handles.
3. Install the battery in the backpack holder.
4. Push the locking handles to lock the battery.
5. Connect the cable to the connector.
6. Put the cable in the clip on the backpack holder.

To start the product

1. To start the backpack battery, push the start button
on the backpack battery. Do not continue with the
steps that follow before the green LED lights is on.
Note: When the backpack battery starts, there is a
startup time of approximately 4 seconds. During the
startup the fans come on and green LED lights on
the battery flashes. When the green LED lights on
the battery are on, the product is prepared for start.
790 - 006 - 13.03.2020
2. Push and hold the start button until the green LED
lights on the user interface come on.
Only use

To stop the product

1. Release the power trigger.
2. Push and hold the stop button until the green LED
light goes out.
3. Remove the cable from the clip on the packpack
holder.
4. Pull the locking handles to unlock the battery.
5. Disconnect the cable from the connector.
6. Remove the battery from the product.
Note: If the backpack battery is not used for more than
30 minutes, the backpack battery stops automatically.
To start the backpack battery, push the start button on
the backpack battery.
11