Makita PK5011C Manual De Instrucciones página 8

To remove the dust cover, follow the installation
procedure in reverse.
Installing or removing abrasive disc
(Optional accessory)
NOTE:
Use sander accessories specified in this manual.
•
These must be purchased separately.
1
2
3
4
012030
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the lock nut onto the spindle.
1
2
012032
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, and then use the lock nut
wrench and securely tighten clockwise.
To remove the disc, follow the installation procedure in reverse.
Installing or removing offset-diamond-wheel
cover (Optional accessory)
2
012044
1. Lock nut
2. Abrasive disc
3. Rubber pad
4. 125 mm dust
cover
1. Lock nut wrench
2. Shaft lock
1. Offset –
diamond - wheel
1
cover
2. Screws
3. Set band
3
When using an offset diamond wheel, install the
offset-diamond-wheel cover.
To install the offset-diamond-wheel cover, insert the set
band through between the tool body and the tube, and
then fit it onto the tool. The notch of the set band position
just below the joint.
Set the offset-diamond-wheel cover and secure it and
the set band by firmly tightening the screws.
To remove the offset-diamond-wheel cover, follow the
installation procedure in reverse.
Installing or removing offset diamond wheel
125 mm, M14 threaded (Optional accessory)
To install the offset diamond wheel, press the shaft lock,
and screw the offset diamond wheel on the tool.
1
012043
To remove the offset diamond wheel, press the shaft
lock, place the lock nut wrench on the holes of the wheel
and turn it counterclockwise.
In case the holes don't match with the lock nut
wrench
012038
Remove the front-edge cover by sliding it. Then press
the shaft lock and hold the two parallel flats of the offset
diamond wheel by a wrench and turn it. If you can't see
the parallel flats, press down the offset-diamond-wheel
cover with your fingers.
8
1. Lock nut wrench
2. Shaft lock
2