Pioneer GM-D1004 Manual De Instrucciones página 4

Amplificador 4 canales clase d
Ocultar thumbs Ver también para GM-D1004:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Section
01
Before you start
! When installing the amplifier, do not allow
parts such as extra screws to get caught be-
tween the amplifier and the automobile.
Doing so could cause malfunction.
! Do not allow this unit to come into contact
with liquids. Electrical shock could result.
Also, damage to this unit, smoke, and over-
heating could result from contact with liquids.
The surfaces of the amplifier and any attached
speakers may also heat up and cause minor
burns.
! In the event of any abnormality, the power
supply to the amplifier is cut off to prevent
equipment malfunction. If this occurs, switch
the system power off and check the power
supply and speaker connections. If you are un-
able to determine the cause, please contact
your dealer.
! Always disconnect the negative * terminal of
the battery beforehand to avoid the risk of
electric shock or short circuit during installa-
tion.
! Do not attempt to disassemble or modify this
unit. Doing so may result in fire, electric
shock or other malfunction.
CAUTION
! Always keep the volume low enough to hear
outside sounds.
! Extended use of the car stereo while the en-
gine is at rest or idling may exhaust the bat-
tery.
About the protection function
This product has protection function. When this
product detects something abnormal, the follow-
ing functions will operate to protect the product
and speaker output.
! The power indicator will turn off and the am-
plifier will shut down in the situations outlined
below.
— If the temperature inside the product gets
high.
— If the speaker output terminal and speaker
wire are short-circuited.
— If a DC voltage is applied to the speaker
output terminal.
— If the battery voltage is outside of the use
range.
4
En
! The amplifier will reduce the power output if
the temperature inside the amplifier gets
high. If the temperature gets too high, the
power indicator will turn off, and the amplifier
will shut down.
Important (Serial number)
The serial number is located on the bottom of
this unit. For your own security and convenience,
be sure to record this number on the enclosed
warranty card.

Publicidad

Tabla de contenido
loading

Tabla de contenido