Mantenimiento; Limpieza - Husqvarna M-ZT 61 Manual Del Operador

MANTENIMIENTO

Limpieza

suciedad se adhiera.
de corte. Utilice aire comprimido para limpiar la
eléctricos con agua.
Utilice siempre gafas de
protección ocular durante el proceso
68
OPERATION
Read the Safety section and following pages, if
Training
riding mowers.
prior to attempting to move the mower under its
until becoming comfortable with controls, use
a reduced throttle speed and reduced ground
furthest forward or reverse positions during initial
operation.
First time users must become familiar with the
mower's movement on a hard surface, such
to operate on turf. Until the operator becomes
comfortable with the mower controls and zero
Steering
To move forward and backward
control lever controls the right wheel.
Moving
Machine By Hand in the Operation section) to
its own power, the operator must sit in the seat
and start the engine (see Before Starting in the
Operation section). Adjust the engine speed to
the blades at this time. Rotate control levers
inward. As long as the control levers have not
will not move.
neutral position and the mower will stop moving.
levers forward to the neutral position and mower
will stop moving.
To turn to the right
While moving in a forward direction, pull the right
maintaining the position of the left lever, this will
slow the rotation of the right wheel and cause the
machine to turn in that direction.
To turn to the left
While moving in a forward direction pull the left
maintaining the position of the right lever, this will
slow the rotation of the left wheel and cause the
machine to turn in that direction.
To zero turn
forward position and the other in the reverse
position, complete the turn.
Roll Bar
Operate the unit with the roll bar in the raised and
no rollover protection when the roll bar is down.
seat belt. Raise the roll bar as soon as clearance
permits.
WARNING!
when the roll bar is in upright position.
WARNING
is free from objects and stones that could be
Before Starting
1. Read the sections on Safety and Controls
before starting the machine.
2.
starting (see Maintenance Schedule in the
Maintenance section).
3.
4. Adjust the seat to the desired position.
5.
pin into the desired cut height.
17