Assembling And Adjustments; General; Fitting The Handlebar; Cutting Height - Husqvarna M53 S Pro Manual De Instrucciones

General

Important Prevent unintentional starting
!
by removing the ignition cable from the
spark plug.

Fitting the handlebar

Take care not to damage the cables and wires when you
fold up the handlebar.
Fold up the upper section of the handlebar by:
1 Fold in the engine brake handle towards the
handlebar.
2 Lift up the handlebar until the handlebar's upper
tubular construction comes directly opposite to the
handlebar's lower section. Tighten the knob correctly.

ASSEMBLING AND ADJUSTMENTS

Cutting height

CAUTION! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.
The cutting height adjustment is spring assisted. The
cutting height can be adjusted in five different steps.
• To lower the cutting height move the lever to the left
and then forward.
• To raise the cutting height move the lever to the left
and then backward.
–
English 7