Joerns Oxford Stature Manual De Instrucciones página 24

Oxford
®
Stature
*THESE CHECKS SHOULD INCLUDE:
1. SPREADER BAR: Check the spreader bar for freedom of rotation and
swing. Check for wear on the central pivot. Check for firm attachment to
the boom.
2. BOOM: Check the attachment of the boom to the mast carriage. Make
sure there is only minimal movement.
3. MAST: Check it is firmly connected to the chassis.
4. MOTOR GEARBOX: This should require no maintenance other than
checking for correct operation and listening for unusual noise.
5. SMART MONITOR: Check the function of the emergency stop button.
Inspect the hand control socket for correct fitting. Check functioning of
the hand control. Check the redundant controls and confirm they operate as
intended.
6. BATTERIES: The batteries are housed in the power pack and should not
require maintenance other than the regular charging as detailed in the
charging instructions. Check that the connections remain clean. Confirm
the battery bracket is secure and undamaged.
7. LEG ADJUSTMENT: Check that the legs operate in both full extensions
(inward/outward).
8. CASTORS: Check all castors for firm attachment to the legs. Check for
free rotation of the castor and the wheels.
9. CLEANING: Wipe down with a clean cloth, using soap and water and/
or any hard surface disinfectant. Harsh chemical cleaners or abrasives
should be avoided as these may damage the surface finish of the lift.
Avoid excessive wetting, especially electrical areas and the opening
to the base of the hoist. We recommend that the cloth is soaked in the
solution, squeeze out excess fluid and wipe hoist surface.
10. LOAD TEST: The load test should be carried out in accordance with the
manufacturer's test procedures (see Service Manual). It is strongly
recommended the testing is carried out by an authorised service dealer.
11. BASE AND WHEELS: Ensure base is even and level (all four wheels are
on the floor).
12. SLINGS: Check for wear and fraying.
13. LUBRICATION: Oil pivot joints, including mast and boom connections,
pedal assembly, spreader bar joint (only if required).
14. HAND SET: Ensure plugged fully into controller.
15. FIXINGS: Check all nuts, bolts, screws and fasteners for excessive wear
and for tightness. Replace as required.
16. QUICK RELEASE PIN: Ensure the pin is securely fitted before lifting, by
pressing the barbed end.
24
English
ü ü ü
ü ü ü
ü ü ü
ü
ü ü ü
ü
ü ü ü
ü ü ü
ü ü
ü
ü ü ü
ü ü ü
ü
ü ü
ü
ü ü