Battery Charge Indicator; Important Charging Notes - Bosch Dremel GO Instrucciones De Funcionamiento

1600A019PE.qxp_Go 5/24/18 3:13 PM Page 8
CHARGING THE TOOL
Your Dremel GO does not come completely
charged from the factory. Be sure to charge
tool prior to initial use.
- Insert USB cable 8 into USB port of power
adapter 9 (Fig. 1).
- Plug power adapter 9 into standard power
outlet.
- Open Micro USB port cover 6 and plug
micro USB plug into Micro USB port 5.
The battery charge indicator 3 indicates the
charging progress. During the charging
process, the indicator flashes green. The
battery is fully charged when the indicator
lights up green continuously.
It is normal for the handle of the tool to get
warm during charging.
Note: The tool cannot be used during the
charging process.
When the battery is fully charged, disconnect
the Micro USB end of the cable 8 from the tool
and close the cover 6.
Unplug the power adapter from the power
outlet (unless you are charging another tool).

BATTERY CHARGE INDICATOR

30% 60% 100%

IMPORTANT CHARGING NOTES

- Lithium-ion battery will hold its charge
while in storage for up to 2 years so it's
always ready when you need it.
Charging the Tool
The battery charge
indicator 3 displays the
charge level of the
battery for a few
seconds after the tool is
switched on and off.
- The charger was designed to fast charge
the battery only when the battery
temperature is between 32˚F (0˚C) and
113˚F (45˚C).
- A substantial drop in operating time per
charge may mean that the battery pack is
nearing the end of its life and should be
replaced. To replace an old battery, contact
Dremel customer
1-800-4-DREMEL. The Dremel Service
Center can install a new battery and ship it
back to you within 48 hours of receiving
your tool.
- If battery does not charge properly:
a. Check for voltage at outlet by plugging
in some other electrical device.
b. Check to see if outlet is connected to a
light switch which turns power "off" when
lights are turned off.
c. Check USB terminals for dirt. Clean
with cotton swab and alcohol if necessary.
d. Check to see if USB cable is properly
connected to the tool and the power
adapter.
e. If you still do not get proper charging,
send tool and power adapter to your
Dremel Service Center.
Note: Use of power adapters or battery
packs not sold by Dremel may void the
warranty.
-8-
service at