Oriented Start-Up Menu - WEG CFW700 Manual Del Usuario

5.2.1 Oriented Start-up Menu

Step Action/Display Indication
1
Monitoring mode.
„
Press the ENTER/MENU key to get into
„
the first level of the programming mode.
3
Press ENTER/MENU when the group is
„
selected.
5
Change the parameter P0317 to "1 – Yes",
„
by using the
7
In this moment the Oriented Start-up
„
routine is initiated and the "CONF" status
is indicated at the keypad (HMI).
T he pa ra mete r "P0 0 0 0 - Acce s s to
„
Parameters" is selected. Change the
password to set the remaining parameters
if necessary. The factory default is 5.
Press the key to the next parameter.
„
9
If necessary, change "P0298 – Application"
„
parameter. This change will affect P0156,
P0157, P0158, P0401, P0404 and P0410
(this last one only if P0202 = 0, 1 or 2 - V/f
modes). The time and level of the IGBT
overload protection will also be affected.
Press the key to the next parameter.
„
key.
First Time Power-Up and Start-Up
Step Action/Display Indication
2
The PARAM group is selected, press the
„
or keys to select the STARTUP
group.
4
The parameter "P0317 – Oriented Start-up"
„
is then selected, press the ENTER/MENU
to get into the parameter content.
6
Press ENTER/MENU to save.
„
8
If necessary, change "P0296 – Line Rated
„
Voltage". This change will affect P0151,
P0153, P0185, P0321, P0322, P0323 and
P0400.
Press the key to the next parameter.
„
10
If necessary, change "P0202 – Control
„
Type" parameter. This guide will only
show the setting for P0202 = 0 (V/f 60 Hz)
or P0202 = 1 (V/f 50 Hz). Refer to the
programming manual for other settings
(V/f Adjustable, V V W or Vector Modes).
Press the key to the next parameter.
„
CFW700 | 49