Basic Application Menu - WEG CFW700 Manual Del Usuario

5.2.2 Basic Application Menu

Step
Action/Display Indication
1
Monitoring mode.
„
Press the ENTER/MENU key to get into
„
the first level of the programming mode.
3
Press ENTER/MENU when the group is
„
selected.
5
I f n e c e s s a r y, c h a n g e " P 0 1 0 1 –
„
Deceleration Time".
Press the
„
parameter.
7
If necessary, change "P0134 – Maximum
„
Speed" parameter.
Press the
„
parameter.
9
If necessary, change "P0136 – Manual
„
Torque Boost" parameter.
Press the
„
parameter.
or key to the next
or key to the next
or key to the next
Figure 5.2: Basic application group
First Time Power-Up and Start-Up
Step
Action/Display Indication
2
The PARAM group is selected, press
„
the or
group.
4
In this moment the Basic Application
„
routine is initiated. If necessary, change
"P0100 – Acceleration Time" parameter.
Press the
„
parameter.
6
If necessary, change "P0133 – Minimum
„
Speed" parameter.
Press the
„
parameter.
8
If necessary, change "P0135 – Max.
„
Output Current" parameter.
Press the
„
parameter.
10
Press the BACK/ESC key to end the Basic
„
Application routine.
Press the BACK/ESC again to go back to
„
the monitoring mode.
keys to select the BASIC
or key to the next
or key to the next
or key to the next
CFW700 | 51