Cuisinart Smart Stick PLUS CSB-78 Manual Del Usuario página 7

HOLD THE BLADE RING BY THE CENTRAL HUB HOLDING RIBS (grips) (K)
ONLY. DO NOT TOUCH THE RAZOR-SHARP BLADES.
Note these important features of the blade ring. The blade ring can be
placed over the plastic blade sheath in two different ways:
If you hold it as in figure A, you will see the word "Sharp" on the blade.
Assemble the blade this side up to use the sharp edge. (See the section on
processing food, page 9, for information about when to use the sharp
edge.)
If you hold it as in figure B, you will see no writing on the blade. Assemble
the blade this side up to use the blunt edge.
See the section on processing food, page 9, for information about when to use
the blunt edge.
There are notches (K) on opposite sides of the interior of the hub. These fit over
ridges on the sides of the plastic blade sheath.
A
Pick up the blade ring by its hub holding ribs (grips) and turn it very slightly
clockwise. This locks it in place on the plastic blade sheath and prevents it
from sliding up during processing.
BLUNT SIDE UP
SHARP SIDE
K-NOTCH
3. Connect the hand blender motor body to the top of the
chopper/grinder attachment cover. Align the spline, in
the chopper/grinder cover's drive shaft with the ribbed
opening on the underside of the motor body. When
aligned properly, slide the two pieces together until they
mate. You will feel and hear a slight click. It may be
helpful to press the rubber release button when sliding
these pieces together.
4. With the hand blender in place, locate the chopper/
grinder cover and place it on top of the prep bowl.
a. Be sure that the 3 ridges (cover slots) at the top of the
prep bowl line up with the 3 notches in the underside
of the chopper/grinder cover, and that the cover
is seated all around the top of the prep bowl.
b. To rotate cover clockwise to secure it to the
prep bowl.
5. Place one hand on the cover of the chopper/grinder
attachment, while gripping the hand blender
motor body handle with the other. Press the High
or Low button with your fingers to start the motor
and run the chopper/grinder.
To turn the unit off, remove your fingers from the
selected button.
6. WHEN THE BLADE STOPS MOVING, remove the
motor body from the chopper/grinder cover, and
remove the cover from the prep bowl.
Whisk attachment
1. Align the end of the whisk (A) with the small opening
of the whisk gearbox (B).
2. Push end into opening until it locks into position (C).
3. Align the motor body with the assembled whisk
attachment and slide the pieces together until you
hear and feel the pieces click together. It may be
helpful to press the release button
when assembling.
7
3.
Motor
body
bottom –
top view
Chopper/
grinder
cover –
top view
4a.
Chopper/
grinder
cover
assembly