Attaching/Detaching The Pioneer Stand; Pdp-5072Hd/Pdp-5071Hd/Pdp-5070Hd - Pioneer PDP-6072HD Manual De Instrucciones

Preparation
05

Attaching/detaching the PIONEER stand

The Plasma Display comes with the PIONEER table top stand
attached. You can also install the display on a rack by
detaching the stand. The method for attaching/detaching the
stand varies depending on the product.
CAUTION
This product can be used only with the attached stand. Using
other stands can result in instability, possibly causing injury.

PDP-5072HD/PDP-5071HD/PDP-5070HD

CAUTION
The weight of a 50 inch Plasma Display is about 34.1 kg (75.2 lbs.),
it has no depth, and is unstable. Therefore, at least two people
must assemble and install it.
Detaching the stand
When removing the stand before you install the speaker,
begin with step 2.
1
Detach the supplied speaker if it has already been
installed.
• To detach the speaker, remove the cable wiring for the
speaker at the rear and screws at the rear of the speaker
and pull it out.
• Use the protective sheet in which the speaker was
wrapped between the speaker and stand.
• Make sure to remove the speaker mounting fittings.
2
With the Plasma Display lying flat, loosen and remove the
two installation bolts ➀ using the enclosed hexagonal
wrench.
26
En
3
Loosen the two installation bolts ➁ halfway using the
enclosed hexagonal wrench.
Table top stand
Sheet
4
While holding the stand securely, slide down the two
installation bolts ➁ in the direction indicated by arrows
and remove them.
NOTE
• Make sure to keep the installation bolts ➀ and ➁ that have
been removed as they are re-used when attaching the stand
to the Plasma Display.
• Place a sheet or protective cover to protect the display from
scratches or damage.
• Work only with the Plasma Display lying flat on a table or
similar surface.
• When lying the Plasma Display down, be careful not to
scratch or damage it.
Attaching the stand again
When the Plasma Display is mounted without the supplied
speaker, begin with step 2.
1
Detach the supplied speaker when the Plasma Display is
being mounted on the wall, with the speaker attached.
• To detach the speaker, remove the cable wiring for the
speaker at the rear and screws at the bottom of the
speaker and pull it out.
Installation bolts ➀
(M8 x 40 mm: black) (Step 1)
Installation bolts ➁
(M8 x 40 mm: black)
(Step 2)
Slide the stand
(Step 3)