Stopping - Husqvarna PP490 Manual De Instrucciones

WS 482 HF:
WS 482 HF is fitted with two mechanical gears. State
which gear is set. For more information on recommended
blades and speeds, see "Recommended blade speeds" in
the "Technical data" section.
>>DRIVE CHOICES
SET GEAR
[GEAR 1]
SET DRIVE MODE
[BLADE]
SET ROT. DIR.
[STANDARD]
SET FUSE
[32A]
CAUTION! A higher speed than the
!
recommended speed can result in
personal injury and damage to the
equipment.
• Set the required drive mode depending on if the power
unit will be used for wall sawing, chain sawing or wire
cutting. (DRIVE CHOICES>SET DRIVE CHOICES)
>>DRIVE CHOICES
SET GEAR
[GEAR 1]
SET DRIVE MODE
[BLADE]
SET ROT. DIR.
[STANDARD]
SET FUSE
[32A]
It is also possible to choose drive mode from the home
screen by using the arrow keys.

Stopping

CAUTION! Always shut off the water
!
supply to the power pack when it is
without electricity.
Follow the instructions in the manual supplied with the
connected tool.
• Press down the power unit emergency stop.
• Shut off the water supply to the power unit.
STARTING AND STOPPING
20 DEC 20:55
20 DEC 20:55
–
English 17