Menu System Explanation - Husqvarna PP490 Manual De Instrucciones

Ocultar thumbs Ver también para PP490:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Menu system explanation

DRIVE CHOICES (1)
SET GEAR (5)
WS 482 HF is fitted with two mechanical gears. State
which gear is set.
Select gear. (WS 482 HF)
- 1. (600-900 rpm)
- 2. (800-1200 rpm)
SET DRIVE MODE (6)
Set the required drive mode depending on if the power
unit will be used for wall sawing or wire cutting.
Select drive mode. (WS 482 HF)
- BLADE (wall sawing)
- WIRE (wire cutting)
SET ROT. DIR. (7)
The direction of rotation can only be altered when the
blade/wire is not moving.
Select the required direction of rotation.
- STANDARD
- REVERSE
SET FUSE (8)
To be able to use full power output, the power unit must
be connected to a 32 A fuse. With a 16 A or 25 A fuse the
power output is lower so as not to overload the fuse.
State which fuse the power unit is connected to.
- 16A
- 25A
- 32A
SET WATER VALVE (9)
The water flow is adjusted with the ball valve at the
incoming water connector on the power pack.
Select type of water regulation.
- "ON" - The water valve is always open.
- "AUTO" - The water valve opens when the rotation
control is turned up from its zero setting. Otherwise the
water valve is closed.
SETTINGS (2)
RUN TIME (10)
Settings for run time.
TIME COUNTER
On activation, a stop-watch is started to count the time the
blade/wire rotates and at least one feed is active.
CLEAR RUN TIME
Resets the stop watch.
14 – English
MENU SYSTEM
CURRENT RUN TIME
Shows current run time.
TIME AND DATE (11)
Set time and date.
SET TIME
State the current time.
SET DATE
State the current date.
TIME FORMAT
Select the required time format.
- 12 h
- 24 h
DATE FORMAT
Select the required date format.
- YYYY-MM-DD
- YYYY/DD/MM
- DD/MM/YYYY
LANGUAGE (12)
Setting of language on the display in the remote control.
Select the required display language.
SET UNITS (13)
Setting of units in the remote control.
Select the required units.
- AMERICAN
- METRIC
PAIR RADIO (14)
Pair the remote control with machine.
Pair the remote control with machine.
RADIO CHANNEL (15)
Setting the radio channel between remote control and the
power pack. The radio channel must be changed when
the operator experiences disturbance or loss of
communication. The remote control must be connected to
machine with a CAN cable.
Select the required radio channel.
- 0 (2.410 GHz)
- 1 (2.415 GHz)
- ...
- 11 (2.465 GHz)
SERVICE (3)
PRODUCT INFO (4)
Information about the unit and the connected tool is
shown.

Publicidad

Tabla de contenido
loading

Tabla de contenido