Introduction; Equipment - ESAB Caddy Mig C200i Instrucciones De Uso

US
Read and understand the instruction manual
before installing or operating.
Dispose of electronic equipment at the recycling facility!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic
Equipment and its implementation in accordance with national law, electrical and/or
electronic equipment that has reached the end of its life must be disposed of at a
recycling facility.
As the person responsible for the equipment, it is your responsibility to obtain
information on approved collection stations.
For further information contact the nearest ESAB dealer.
ESAB can provide you with all necessary welding protection and accessories.
2

INTRODUCTION

Mig C200i is a portable welding power source in a compact design, intended for
GMA welding.
It is possible to switch between welding with solid wire/shielding gas and welding
with selfshielded cored wire without gas.
The power source operates with wire diameters from
mixed gas or pure CO
2.1

Equipment

The power source is supplied with:
S
Instruction manual
S
Welding gun MXL
S
Return cable with clamp (9.8 ft, fixed)
S
Mains cable (9.8 ftm, fixed, with plug)
S
Shoulder strap (see page 12)
S
Gas hose with quick connection (14.8 ft)
ESAB's accessories for the product can be found on page 69.
bc22a
may be used as shielding gases.
2
TM
180 (9.8 ft, fixed)
- 10 -
 .024 to  .040". Pure argon,