RIDGID R4210 Manual Del Operador página 12

FEATURES
EXTENDED MITER CAPACITY
Rotating extension tables allow for miter cuts up to 70°.
LOWER BLADE
GUARD
HEAD LOCK PIN
See Figure 4.
The head lock pin is used for locking the saw arm in the
SLIDING
down position.
MITER FENCE
SLIDE
LED LIGHTING SYSTEM
BAR
The LED casts a shadow of the blade teeth onto the
SLIDE
workpiece for making precision cuts and predicts blade kerf
LOCK
for blade cut line.
KNOB
MITER DETENT OVERRIDE LEVER
See Figure 5.
The miter detent override lever allows you to make adjust-
ments to the miter angle without holding the miter detent
button. To use the miter detent override lever, unlock the
1
miter lock lever, push the miter detent bypass button (1) and
move the miter detent override lever down (2) to engage the
2
override.
MITER SCALE
Indexed miter stops have been provided at 0°, 15°, 22.5°,
31.6°, 45°, 60°, and 67.5°. The 0°, 15°, 22.5°, 31.6°, 45°, 60°,
and 67.5° indexed miter stops have been provided on both
the left and right side of the miter table.
Fig. 5
SELF-RETRACTING LOWER BLADE GUARD
See Figure 5.
The lower blade guard is made of shock-resistant plastic that
provides protection from each side of the blade. It retracts
over the upper blade guard as the saw is lowered into the
workpiece.
SLIDE BAR
When unlocked, the saw arm will glide forward and back-
ward the length of the slide bar for cutting various workpiece
widths.
SLIDE LOCK KNOB
See Figure 5.
The slide lock knob locks and unlocks the sliding feature
of this tool.
12 - English