RIDGID R4210 Manual Del Operador página 24

ASSEMBLY
TO ADJUST THE BEVEL
See Figures 28 - 29.
 Remove the bevel lock dust cover.
 Move the bevel bypass lever to the detent disengaged
position.
 Set the bevel at any angle that allows access to the 4
screws on the back of the bevel lock bracket.
 Tighten the bevel lock knob.
 Using a 4 mm hex wrench, loosen the 4 screws that hold
the bevel detent plate in place. Do not remove the screws.
 Loosen the bevel lock knob and move the bevel bypass
lever to the detent disengaged position.
 Set the bevel angle at 0°.
 Move the bevel bypass lever to the detent engaged posi-
tion.
 Check the 0° angle using a combination square.
 If adjustment is needed, use a 4 mm hex key to turn the
micro adjust screw on the front of the bevel lock bracket
to adjust the saw to the 0° bevel angle.
 Tighten the bevel lock knob.
 Tighten the 2 outermost screws that retain the bevel
detent plate.
 Loosen the bevel lock knob and set the bevel at any angle
that allows access to the 2 remaining screws on the back
of the bevel lock bracket.
 Tighten the bevel lock knob.
 Tighten the remaining 2 screws that retain the bevel de-
tent plate.
 Replace the bevel lock dust cover and tighten the screws
securely.
SCREWS
BACK OF BEVEL LOCK BRACKET
SCREWS
FRONT OF BEVEL LOCK BRACKET
MICRO ADJUST
SCREW
24 - English
BEVEL BYPASS
LEVER
BEVEL LOCK
BEVEL LOCK
DUST COVER
BEVEL DETENT
KNOB
Fig. 28
SCREWS
PLATE
Fig. 29