RIDGID R4210 Manual Del Operador página 36

OPERATION
Bevel
Angle Type of Cut
Setting
Left side, inside corner
1. Top edge of molding against fence
0°
2. Miter table set right 45°
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
0°
2. Miter table set left 45°
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
0°
2. Miter table set left 45°
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
0°
2. Miter table set right 45°
3. Save right end of cut
CUTTING NESTED CROWN MOLDING USING
CROWN STOPS
(Crown Stops Sold Separately as an Accessory)
See Figure 48.
Crown stops may be purchased as an accessory to this saw
for use in cutting crown molding in a nested position and
should be installed on both the right and left side.
To attach the crown stops to the extension table:
 Position a crown stop on the right extension table.
 Insert the threaded crown stop lock knob through the
long slot in the crown stop and into Hole A as shown, but
do not fully tighten to allow for adjustment of the crown
stop.
 Set the top of the piece of crown molding on the table.
Position the spring angles so that the bottom angle is flat
on the table and the top angle is flush against the miter
fence.
 Tighten the lock knob securely before making the cut.
NOTE: Hole B is used for extended miter cuts when the
rotating extension table is in the farthest outboard posi-
tion.
 Repeat steps for the left side.
HOLE "B"
36 - English
LOCK KNOB
CROWN
HOLE "A"
STOP
CROWN
STOP
Fig. 48