Autoadapt Turny HD Manual De Instalación página 12

12
Turny Getting seated
Installation
Check that the delivery has not been damaged during transit and that its contents
match the order details. If you have any problems, please contact support@autoadapt.se.
Disconnect the vehicle battery to minimise the risk of error codes in the
!
vehicle system.
Remove the female belt connector, the lower anchor bracket for the belt
!
and the seat. Where there are airbags that have to be removed, replace
them with a resistor; see the console instructions in question.
If Turny is overloaded it will stop. The display on the control card will indi-
!
cate "C" and the LED on the left of the manual control will flash red.
If Turny encounters an obstruction it will stop and then reverse slightly.
!
The display on the control card will indicate "F" and the LED on the left
of the manual control will flash red.
Always use the crank for manual operation of Turny. Stop at least 2 cm
!
before the end position to prevent damage to the motor; see the illustra-
tion below.
Never replace with or connect a cable to another one with a smaller di-
!
mension.
2 cm