NORPOLE NPDH30 Manual De Usuario página 10

2. Continuous Draining: Water can be drained automatically into a floor drain by
attaching the threaded female end of a 5/16" I.D. water hose (sold separately)
to the drain hose adaptor located in the water bucket. Remove the plastic
cover from the drain outlet on the back of the unit and set aside. Remove the
water bucket and insert the drain hose through the drain outlet. Securely press
the drain hose of the adaptor into the connector on the front of the unit. Tighten
the adaptor securely with the included two screws (located in the bucket).
Plastic Cover
Drain Hose Subassembly
Make sure the connection is tight and there is no leak. Attach the water hose and run it to the floor
drain or a suitable drainage facility, making sure that it is lower than the drain outlet of the unit. The
water hose should slope downward to allow the water to flow out smoothly.
NOTE: When the continuous drain feature is not being used, remove the drain hose from the
outlet and put the plastic cover back onto the drain outlet.
Connector
Drain Hose
10
Drain Hose
Adaptor A
Female
Threaded
End
Water Hose
Figure 10
Figure 10