NSK PRESTO AQUA LUX Operación Manual página 4

2. Specifications
Control Unit
Model NE272
LED Power Range 3.5Vdc 0.7A
Control Unit Dimensions W235XD139XH182 ( mm )
Power Supply 5Vdc
Air Volume 30 ~ 40 L/min
(0.25 ~ 0.3 MPa)
Water Pressure 0.1 ~ 0.3 MPa
Water Volume 0 ~ 45L/min
Water Tempter 0 ~ 40 ˚C
3. Installation Procedures for Each Part
( 1 ) Installation Procedures for Each Part
Push the plumbing hose into the Plumbing Connector
located at the regulator on the left-hand side of the
Control Unit. Connect Plumbing Hose and Control Unit as
shown in Fig.1. Check if the hose is securely installed by
slightly tugging it after connection. Connect the other end
of the plumbing hose to the air line. At this time, use the
attached connector if necessary.
CAUTION
• Push the plumbing hose into the connector until it is securely set. Otherwise, air may leak.
• Pushing the white ring, on the plumbing connector, gently remove the tube.
( 2 ) Installation of AC Power Supply
Insert the AC Adapter into Power connector firmly.
Handpiece
Speed -1
320.000min
Proper Air Supply Pressure 0.25~0.3MPa
Handpiece Dimensions ø16.6 X104 ( H ) mm
AC Adaptor
Model NE271
100 ~ 240 Vac
Power/Voltage
50 ~ 60 Hz 0,4A
White Ring
Plumbring Connector
Plumbring Hose
Power Connector Power Connector Power Connector
AC Adapter AC Adapter AC Adapter
4
( 3 ) Installation of Foot Control
Loosen and remove the Hose Stoppers ( two ) from the
Foot Control Connectors on the back of the Control Unit,
and insert them into Foot Control Connector the Foot
Control hoses. At this time, insert the Hose Stoppers so
that their screws come outside ( Control Unit Side ) .
Insert the "1"-marked end of each hose according to the
instructions on the label. After insertion of both hoses,
securely tighten the hose stoppers. ( Fig.3 )
( 4 ) Installation of Handpiece
Connect the Handpiece Hose to the Handpiece Connector on the front of the Control Unit ( Fig.3 ) . Attach the handpiece to the
Coupling Hose by pulling back the sleeve of the Coupling Hose insert the handpiece and release the sleeve. ( Fig.5 )
Handpiece Connector
Coupling Hose
Fig.1
( 5 ) Installation and Removal of Water Supply Bottle
<Installation>
Press the Bottle Attaching/Detaching release button on
the back of the Control Unit until it engages and is locked.
( Fig. 6 ) Insert the Water Supply Bottle from above and
push downwards until the Bottle Attaching/Detaching
release button returns to its original position. Check to see
if the water supply bottle is securely held in place pull it
upwards.
CAUTION
Fig.2
Check to see if the Bottle Attaching/Detaching release button has returned to its original position and the Water
Supply Bottle is securely held in place. If it is not securely held in place water and air may leak, and the Water
Supply Bottle may pop out.
Foot Control Connector Foot Control Connector Foot Control Connector
Hose Stopper Hose Stopper Hose Stopper
Coupling Hose
Fig. 4
2
Water Supply Water Supply Water Supply
Bottle Bottle Bottle
Bottle Attaching/Detaching Bottle Attaching/Detaching Bottle Attaching/Detaching
release button release button release button
1
5
Fig. 3
Fig. 5
Fig. 6