After Operation - NSK PRESTO AQUA LUX Operación Manual

Ocultar thumbs Ver también para PRESTO AQUA LUX:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

<Removal>
Holding the Water Supply Bottle, press the Bottle
Attaching/Detaching release button until it is locked, keep
pressing Attaching/Detaching release button while holding
the Control Unit and pull Water Supply Bottle upwards.
( Fig.7 )
CAUTION
After use, if water is low in the Water Supply
Bottle, the Water Supply Bottle may pop out
while pressing the release button; therefore you
must make sure the Water Supply Bottle is held
securely when pressing the release button.
(6) Installation and Removal of the Water Supply Bottle Cap
<Installation>
Check the seal inside the Water Supply Bottle Cap for misalignment or detachment before clsoing the Water Supply Bottle
Cap. ( Fig.8 )
<Removal>
Before opening the Water Supply Bottle Cap, be sure to press the Bleeder Button to release the pressure in the Water
Supply Bottle. (Fig. 9) Check that the pressure is completely released before opening the Water Supply Bottle Cap.
Packing
Packing
Packing
Water Supply
Water Supply
Water Supply
Bottle Cap
Bottle Cap
Bottle Cap
( 7 ) Installation and Removal of Water Filter Set ( Use of Main Water )
Push the hose of the water filter set ( the end with the
water filter ) into the tap water connector on the back of
the Control Unit until it is securely held in place as shown
in Fig. 10. Check if the hose is securely held in place by
slightly tugging it after connection. Connect the other end
of the hose to the tap water line.
CAUTION
To disconnect push the white ring on the water connector towards the control unit and gently pull the tube out of
the connector.
3
1
Water Bottle
Water Bottle
Water Bottle
2
Bleeder Button
Bleeder Button
Bleeder Button
Fig. 8
Water Connector
Water Connector
Water Connector
White Ring
White Ring
White Ring
Hose
Hose
Hose
Water Filter Case
Water Filter Case
Water Filter Case
6
4. Operational Procedures of Control Unit
( 1 ) Set the Drive Air Pressure
Connect to compressed air supply air and adjust to 0.3MPa by pulling the Chip Air Adjustment Knob upward and turn in the
desired direction. When adjusted correctly push the knob down to lock.
( 2 ) Set the Water Supply
Depending on the water supply you must set the Water
ON/OFF switch in the correct position by pulling outwards
or pushing inwards.
<Use of Water Supply Bottle>
Fig. 7
Push the Water Mode Select Switch inwards until it stops.
( Fig.11 ) .
<Use of Tap Water>
Pull the Water Mode Select Switch outwards until it stops.
( Fig. 11 ) Open the main cock of the tap water.
CAUTION
Properly set the Water Mode Select Switch in the ON/OFF position. If the switch is not in the correct position air
may enter the system.
( 3 ) Operation
Depressing the Foot Control starts operation. If the Water ON/OFF switch is set to the ON side, water supply is also started.
( 4 ) Adjustment of the Amount of Water Supplied
Check the amount of water and adjust the volume with the Water Adjustment Knob.
CAUTION
• When Tap water is used, the water pressure may differ depending on the location, resulting in varying water
supply; therefore adjustments may be necessary.
Fig. 9
• Leaving this product for a long time after using it with fine water mist may cause air ingress in the handpiece
hose. This could result in a slow down the water flow when starting up the handpiece. In this case, turn the
water volume up fully to clear the line and reduce again as necessary.
( 5 ) Adjustment of Chip Air
Check the spray condition and adjust the amount of Chip Air with the Chip Air Adjustment Knob. Increasing the chip air
results in water turning from jet to spray and finally to fine mist. Decreasing the Chip Air has the reverse effect.
( 6 ) LED ON/OFF
LED switch is turned 'ON' it will illuminate once the Foot Control is depressed.
( 7 ) LED Light Adjustment Knob
Fig. 10
Check the LED light condition and adjust the amount of light with the LED Light Adjustmen Knob.

(8) After Operation

After completion of operation always close the main air cock.
Water Mode Select Switch
Water Mode Select Switch
Water Mode Select Switch
Use of Water Supply Bottle
Use of Water Supply Bottle
Use of Water Supply Bottle
Use of Tap Water
Use of Tap Water
Use of Tap Water
( when water supply is used )
( when water supply is used )
7
Fig. 11

Publicidad

Tabla de contenido
loading

Tabla de contenido