Brandt BFC582LNW Guia De Instalacion página 34

① Door holder
② Stop block
③ Self-tapping screws
8. Change screw hole covers on middle
cover plate from left to right (as shown
In figure below).
9. Place refrigerator flatwise, remove
part ③ and then loose screws ④ .
Remove part ② and part ① .
Washer
① Lower hinge part (right) Note : washer may
② Front foot fixed board stick to lower door
③ Adjustable bottom fett part
④ Self-tapping screws
10. Unscrew the lower hinge, change it
to the near hole site, and then screw up
and mount the washer.
11. Repeat the step 9, change part ① to
left and part ② to right and then fix
them with screws ④ . Finally install part
③ .
Lower hinge part left
12. Move the lower door and adjust its
position to align lower hole site and
upper hinge axis. Turn the middle
hinge by 180, change the washer on
the axis to the upper side, adjust the
middle hinge to the
position and then install it.
Note: washer may
stick to lower door
13. Unscrew the upper hinge axis, turn
the upper hinge over and fix axis on it.
Then place it at side for use.
12
appropriate
Washer