Maintenance Checklist - Upright SL20 Manual Del Operador

P
REVENTATIVE
P M
REVENTATIVE AINTENANCE
Interval
Daily = each shift or every day
50h/30d = every 50 hours or 30 days
250h/6m = every 250 hours or 6 months
1000h/2y = every 1000 hours or 2 years
Y = Yes/Acceptable
N = No/Not Acceptable
R = Repaired/Acceptable
COMPONENT INSPECTION OR SERVICES
Battery Check electrolyte level.
Check specific gravity.
Clean exterior.
Check battery cable condition.
Clean terminals.
Hydraulic Check oil level.
Oil
Change filter.
Drain and replace oil.
Check for leaks.
Hydraulic
System
Check hose connections.
Check hoses for exterior wear.
Emergency
Operate the emergency lowering valve
Hydraulic
and check for serviceability.
System
Controller Check switch operation.
Control Check the exterior of the cable for
pinching, binding or wear.
Cable
Check fasteners for proper torque.
Platform
Deck and
Check welds for cracks.
Rails
Check condition of deck.
Check for damage.
Tires
Check lug nuts (torque to 108 N·m
[80 ft. lbs.]).
Wipe clean.
Hydraulic
Pump
Check for leaks at mating surfaces.
Check for hose fitting leaks.
Check mounting bolts for proper torque.
Drive
Check for operation and leaks.
Motors
SL20
M C
AINTENANCE
K
EY
INTERVAL
Daily
6m
6m
Daily
6m
Daily
6m
2y
Daily
30d
30d
Daily
Daily
Daily
6m
Daily
Daily
Daily
6m
30d
30d
Daily
6m
Daily
HECKLIST
P
REVENTATIVE
Date: _________________________________________
Owner: ________________________________________
Model No:______________________________________
Serial No: ______________________________________
Serviced By:____________________________________
Service Interval: _________________________________
COMPONENT INSPECTION OR SERVICES
Y N R
Steering Check hardware & fittings for proper
torque.
System
Grease pivot pins.
Oil king pins.
Check steering cylinder for leaks.
Inspect for structural cracks.
Elevating
Assembly
Check pivot points for wear.
Check mounting pin pivot bolts for proper
torque.
Check elevating arms for bending.
Chassis Check hoses for pinch or rubbing points.
Check component mounting for proper
torque.
Check welds for cracks.
Lift Cylinder Check the cylinder rod for wear.
Check mounting pin pivot bolts for proper
torque.
Check seals for leaks.
Inspect pivot points for wear.
Check fittings for proper torque.
Entire Unit Check for and repair collision damage.
Check fasteners for proper torque.
Check for corrosion-remove and repaint.
Lubricate.
Labels Check for peeling, missing, or unreadable
labels & replace.
M R
AINTENANCE EPORT
INTERVAL
30d
30d
30d
Daily
Daily
Daily
30d
30d
Daily
30d
Daily
Y N R
6m
6m
6m
6m
6m
6m
6m
6m
6m
6m
11