Wagan Tech Elite 400W PRO Manual De Usuario página 10

Elite™ 400W PRO by Wagan Tech
5. Place the ON/OFF power switch in the "ON" position. The green LED
should turn on, indicating the inverter is powered and operating normally.
6. When the inverter is not in use, place the inverter's ON/OFF Power Switch
to the "OFF" position. We recommend also unplugging the DC Adapter
cable from the vehicle's DC outlet.
Battery Clip Adapter Cord – Up to 400W Output
1. Connect an insulated copper wire to the ground terminal. The other end
of the ground wire should be connected to a proper grounding point. Use
the shortest practical length of wire. Connect this wire to the chassis of
your vehicle or to the grounding system in your boat. In a city, the ground
wire can connect to a metal cold water pipe that goes underground. In
remote locations, the ground wire can be connected to an earth ground.
In the unlikely event of a short circuit, operating the inverter without proper
grounding can result in electric shock. Do not directly connect this ground
wire to the negative DC terminal
2. Connect just the red terminal of the supplied DC Battery Clip Adapter Cord
to the red stud terminal (+) on the rear of the inverter.
3. Connect the two battery clips to the battery.
Be sure to connect the clips to the correct polarity battery terminals.
ƒ
Reverse polarity connection will blow the fuse in the inverter and
can permanently damage to the inverter. Damage caused by reverse
polarity will void the warranty.
4. Connect the Negative black (−) connector to the stud connector on the
rear of the inverter. There may be a momentary spark and the low voltage
buzzer may briefly sound.
8
®
www.wagan.com