Installation Instructions - HQ-Power OFK7 Manual Del Usuario

 Familiarise yourself with the functions of the device before actually
using it.
 All modifications of the device are forbidden for safety reasons. Damage
caused by user modifications to the device is not covered by the
warranty.
 Only use the device for its intended purpose. Using the device in an
unauthorised way will void the warranty.
 Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.
 Keep this manual for future reference.
4. Features
 colour: smooth RGB colour mixing
 IC remote controller
5. Overview
Refer to page 2 of this manual.
1 fibres
2 IR input

6. Installation Instructions

As we have included all required components to form this kit, the installation
is very simple. Drill holes, a little larger than the fibre diameter (see below),
in your false ceiling. Insert the fibres [1] into the holes and fix them on the
backside of the ceiling with some silicone glue.
Insert the power plug of the included USB cable into the power input [3].
Connect the unit to a powered USB output of a computer.
Insert the plug of the IR sensor into to the IR input [2] of the unit. Install
the IR sensor in an accessible location in the room.
7. Operation Instructions
Refer to page 2 of this manual.
Make sure to install the CR2025 battery into the remote control. Mind the
correct polarity.
Switch on and off with the on and off switch [c].
Choose your colour by pressing one of the coloured buttons [b] on the
remote control.
Choose your effect by pressing one of the effect buttons [d] on the remote
control.
Set the colour intensity or the effect speed with the control buttons [a].
V. 02 – 26/03/2015
OFK7
3 power input
4 ©Velleman nv