Configuration Of The Control Panel - Dea NET24N Instrucciones De Uso Y Advertencias

4 CONFIGURATION OF THE CONTROL PANEL

The universal control unit NET24N can be used for the management of the following types (
System: swing and sliding gates, overhead doors and barriers.
In order to ensure maximum adaptability to each
at the first turn, for the optimal configuration of inputs, outputs and parameters (see diagram
will operate in the mode "dedicated" to the
the standard programming for the installation on which it is operating.
All settings remain in memory even in the case of subsequent flare-ups (see diagram
If necessary the of configured closing can be later adjusted following diagram
FIRST CONTROL BOARD IGNITION
Configuration after the first ignition
For the first control panel ignition, proceed as
follows:
1. Apply power, the display shows in sequence the
writing " " and "
2. Press the button and hold for 5 seconds until
the display shows on the display;
3. Acting on the and keys, select the desired
configuration depending on the type of installa-
tion (es. ) and confirm by pressing the
button;
At this point, the selection will be stored and
reloaded each time in the future.
4. Follow signs, " ", "
symbol of closed gate "----".
Following ignitions
If you have already saved a configuration, pro-
ceed as follows:
Apply power, the display shows in sequence the
writing " ", " ", "
symbol of closed gate "----".
Modify the existing configuration
If you have already saved a configuration and
you want to change it, proceed as follows:
1. Hold down the button and give power, the
display shows in sequence the writing "
and " " flashing;
2. Press the button and hold for 5 seconds until
the display shows (the value changes to
match the previous configuration used) on the
display;
3. Acting on the and , select the new desired
configuration depending on the type of installa-
tion (es. ) and confirm by pressing the
button;
Stop the reconfiguration procedure prior
to confirmation, involves loading the pre-
vious configuration by the control panel wi-
thout any modification.
However, if the reconfiguration proce-
dure is brought to an end, the new confi-
guration will take the place of the previous
one and will be reloaded each time in the
future.
4. Follow signs, " ", "
symbol of closed gate "----".
of closure, the control board provides an initial procedure, performed only
of selected closing. After performing the initial configuration it is sufficient to execute
" flashing;
" followed by the
" followed by the
"
" followed by the
) of closures motorized by DEA
). Once configured, the control panel
).
.
Sliding gates
Swing gates
Overhead doors
Barriers
21