Optional Extras / Accessories - Earlex SprayStation HV2901P Manual De Instrucciones

OPTIONAL EXTRAS / ACCESSORIES

Needles and fluid tips of different sizes can be obtained as sets under the following accessory
numbers:
1.0mm dia Fluid Tip, Needle and Air Cap HVACV1*
1.5mm dia Fluid Tip, Needle and Air Cap HVACV15*
2mm dia Fluid Tip, Needle and Air Cap
*When ordering these you MUST also order HVACV8 (Conversion Kit).
SET-UP
To view the 'How to' video please go to www.earlex.com.
NEEDLE AND TIP
Needle and Tip
2.5mm (in Spray Gun (Fig.1))
• Select and fit the needle/tip you require to the spray gun (see cleaning instructions).
• Fill the Paint Container (12) with the product to be sprayed. Stir well (as mentioned previously) and
>strain to remove any bits which may interfere with a smooth consistent spray.
• Make sure the Paint Container Seal (10) and Pick-Up Tube (11) are firmly fitted into the base of the
>Spray Gun.
• Angle the Pick-Up Tube (11) 'forwards' if spraying downwards. Angle Pick-Up Tube (11) towards rear
>of gun if spraying upwards (Fig. 3).
• Screw the Paint Container (12) to the base of the Spray Gun and tighten accordingly.
• Start with the Paint Flow Adjuster (9) at its minimum setting so the trigger cannot be pulled. Do not
>forget that the Paint Flow Adjuster (9) controls the quantity of paint sprayed (Fig.4).
• Uncoil the Air Hose (13) and attach it to the back of the Spray Gun and the other end of the air hose
>to the SprayStation.
• Uncoil the power cord and attach the plug to the mains supply.
• Switch the SprayStation ON. This will immediately cause some air to be produced, which is quite
>NORMAL. However, none of the product will be sprayed until the Spray Gun trigger is pulled.
• VERY IMPORTANT: When spraying for the first time, we recommend you run the motor for
approximately 1 to 2 minutes before applying the product. Do not forget that the Paint Flow Adjuster
(9) controls the quantity of paint sprayed (Fig.4).
ALWAYS MAKE SURE THAT THE MOTOR UNIT IS ON A RIGID AND LEVEL SURFACE AND
FREE FROM DUST.
2.5mm dia Fluid Tip, Needle and Air Cap HVACVP25
HVACV2*
Best used with the following
Medium-to-thick bodied materials for a coarse finish
6