Fitting The Platform - TELETOWER TTA02 Manual De Instrucciones

English

2. FITTING THE PLATFORM

WARNING. The platform must ALWAYS be mounted on RUNG 3 except when
the TELETOWER® is being used in "PODIUM" mode.
Fully unfold the platform until it is straight. It will lock straight automatically. Ensure
1.
it has locked in this position, see Figure 2.1.
2.1
HOLD SIDE FRAME HERE
WHEN LIFTING PLATFORM
LOCATION
BRACKETS
The platform has four location brackets fitted one near each corner on the
2.
underside to correctly locate and secure the platform on the rung as shown in
Figure 2.1 and Figure 2.2. RUNG 3 has two locator guides on the inner face of the
rung for positioning the platform correctly, see Figure 2.3.
WARNING. When lifting the platform, hold the side frames only. Take care NOT
to hold it via the underside panel as there is a trapdoor in the panel. This will
open if you try to support the weight of the platform at this point.
PLATFORM
RUNG 3
12
TOE BOARD
FIXING BRACKETS
TOE BOARD
FIXING BRACKET RELEASE LEVER
2.2
LOCATION
BRACKET
3
Always place Platform
at this level
RUNG
LOCATION
HOLD SIDE FRAME HERE
WHEN LIFTING PLATFORM
LOCKING HINGE
PLATFORM
RUNG 3
1.00m
BRACKET
(HIDDEN)
TRAP DOOR
LOCATION
BRACKET
TOE BOARD
FIXING BRACKET
2.3
LOCATION
BRACKET
LOCATION
BRACKET
GUIDE
(1 OF 4)