RIDGID JP06101 Manual Del Operador página 25

OPERATION
SETTING THE FENCE FOR A 135° BEVEL STOP
See Figure 37.
 Loosen bevel lock handle.
 Flip the 90° stop bar out of the way and move the fence
until it contacts the 135° stop.
 Make sure fence is tight against the stop and check the
angle using the included angle gauge.
 Using the angle gauge, set the fence at 135° to the outfeed
table and tighten the bevel lock handle.
 Loosen the jam nut on the 135° stop screw.
 Turn the stop screw so it touches the stop. Tighten the
jam nut.
 Loosen the bevel lock knob.
 Move the fence to any angle and then return it to the
index. Check for accuracy with the angle gauge.
FENCE LOCK
KNOB
FENCE
25
135° STOP
SCREW
BEVEL LOCK
HANDLE
ANGLE
GAUGE
Fig. 37