Genius Audio GTM-1000.1D Manual Del Usuario página 12

Be prepared to turn off the alarm on your vehicle and for
AMPLIFIER GLOSSARY TECHNICAL AND FUNCTIONS
1. RCA audio input
Use high-quality Genius stereo RCA cables, connect
the signal from the audio player to the amplifier's RCA
inputs.
2. Sensitivity level GAIN
Adjusts the "pre-amplified" sensitivity level of the
amplifiers. The minimum sensitivity level is 200 mV,
while the maximum level is 5V.
3. Subsonic Filter
Subsonic filter is for very low frequencies, this helps
to cut some of those frequencies which are not totally
audible, these frequencies can be harmful to the
subwoofer and this control filters from 0 Hz to 50 Hz.
4. Low Pass Crossover
Adjust the frequency setting of the Low Pass Crosso-
ver. The adjustable frequency range is 40Hz-180Hz.
The frequencies higher than the setting, are filtered in
the audio signal. (All the frequency above the setting
will be filtered). All audio signals below the set level
will pass up to 40Hz.
5. Remote Control
Special input to control the volume level of the
remote subwoofer
6. BASS BOOST
Low frequency boost control adjustable from 0 db to
12 db / 8va.
7. LED POWER indicator
When the amplifier is on and in operating condition,
this LED will light blue.
- 12 -
CAUTION:
enter the unit code player radio.
GTM-1000.1D
8. LED Protection Indicator
If the amplifier activates the protection mode,
this LED will light red.
9. Powering the Amplifier
The B (+) and GND (GND) power supplies use a
4 AWG gauge while the remote uses a 12 AWG
gauge input (the REM terminal is used to
remotely turn the amplifier on and off when a
Voltage 12V)
10. Speaker Terminals
The loudspeaker terminals are nickel plated
that allows the connection of cables of
maximum size 10 AWG for the power of the
horn. NOTE: The configuration of each
channel must be checked by qualified
personnel.
11. Bass Boost Frequency:
Control that allows to increase the low frequen-
cies from 30 Hz. - 80 Hz.
12. Bridge IN / Bridge OUT:
Link-Dual connection is where one amplifier
has control over the other, it is basically used to
double the power between both amplifiers. Also
known as LINK-Dual Master / Slave, where the
BRIDGE OUT (Master) and Bridge IN (SLAVE)
GT TECHNOLOGY