Threading The Machine - Singer 6038 Manual De Instrucciones

SINGER
Threading the
machine
I
A
1. Place spool or spun on spool pino Use
adequate clamp to firmly fix it.
2. Lift the presser foot, and turn the hand
wheel towards your direction until the
take-up leve r reaches its highest position.
3. Lead thread passing it first through the
2
lower slot of the thread guide. Next
through the upper slot, leading the thread
to the right and around (illustration 1).
4. Pass the thread through the other thread
guide, by inserting it from the botton to
the top (illustration 2).
5. Pass the thread round the tensor,
50
that
they remain between the tensor disks
(illustration 3).
6. Pull the thread slightly up, by raising the
spring (illustration 4) and allowing that the
thread to slide inside the protector
(illustration 5).
7. Pass the thread through the thread guide,
as shown in the illustration 6.
6