Toyotomi TRG-828ZR Manual De Usuario página 24

REPLACEMENT OF BATTERIES IN REMOTE CONTROLLER
1. Press the back side of remote controller marked
with "OPEN" and then push out the
cover of battery box along the arrow direction.
2. Replace two 7# {AAA 1.5V) dry batteries, and
make sure the position of "+" and "-" polar
are correct.
3. Reinstall the cover of battery box.
NOTE:
•
During operation, point the remote control signal sender at the receiving window on
indoor unit.
•
The distance between signal sender and receiving window should be no more than 8m,
and there should be no obstacles between them.
•
Signal may be interfered easily in the room where there is fluorescent lamp or wireless
telephone; remote controller should be close to indoor unit during operation.
•
Replace new batteries of the same model when replacement is required.
•
When you don't use remote controller for a long time, please take out the batteries.
•
lf the display on remote controller is fuzzy or there's no display, please replace batteries.
Signal sender
24
Batteries
Reinstall
Remove
Cover off battery box
GB