Tabla De Contenido; Safety Symbols - skilsaw SPT88 Instrucciones De Funcionamiento

Safety Symbols ........................................... 2
General Safety Rules for Benchtop Tools
...................................................................3-7
Additional Safety Rules ..........................8-9
Operator's Glossary Of Terms ...........10-11
Getting To Know Your Miter Saw .......12-14
Assembly..............................................15-17
Unpacking And Checking Contents ........ 15
Tools Needed For Assembly And
Alignment................................................ 15
Installation Of Miter-Lock Knob .............. 16
Removal And Installation Of The Blade.. 16
Using Carbide-Tipped Blades................. 17
Adjustments .........................................17-21
Bevel Square To Table Adjustment ........ 17
Adjusting Bevel-Scale Pointers .............. 18
Bevel Stop 45° Right And Left Adjustment
.................................................................... 18
Miter-System Adjustment ....................... 19
Depth-Of-Cut Adjustment ..................20-21
Transporting And Mounting ...............22-24
Transporting ......................................22-23
Preparing to Lift the Saw ........................ 23
The definitions below describe the level of severity for each signal word. Please read the manual
DANGER
WARNING
CAUTION
2
Table of Contents
Page

Safety Symbols

and pay attention to these symbols.
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that follow this
symbol to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION, used with the safety alert symbol, indicates a hazardous
situation which, if not avoided, will result in minor or moderate injury.
Mounting the Saw ................................... 24
Saw Operations ...................................25-35
Switch ..................................................... 25
Body And Hand Positions ....................... 25
Led Shadowlight ..................................... 26
Installing The Work Clamp ..................... 27
Slide Cut ................................................. 27
Miter System ......................................28-35
Maintenance And Lubrication ............36-37
Gear Lubrication ..................................... 36
Carbon Brushes...................................... 36
Troubleshooting ...................................... 37
Page