Transporting And Mounting; Transporting - skilsaw SPT88 Instrucciones De Funcionamiento

Transporting

WARNING
below by the Bullet (•) symbol.
Unplug the electric cord and wind it up.
•
Never lift the saw by gripping any of the
•
mechanism parts. The saw may move
and cause severe injuries to your fingers or
hands.
To avoid back injury, hold the tool close
•
to your body when lifting. Bend your
knees so you can lift with your legs, not with
your back.
WARNING
from the power source before performing
any assembly, adjustments, or repairs.
Head-assembly Lock Pin
The head-assembly lock pin (Fig. 14) is used
to hold the head assembly in the DOWN
position. This position prevents the head
from moving up and down during transport
and makes the saw more compact for lifting
and storage. This position is also required for
some calibration procedures.
To Engage the Head-Assembly Lock Pin:
1. Check that the depth-of-cut stop and
the dimensional-lumber preset stop are
disengaged.
2. Grasp the main handle and press down on
the head assembly.
To Disengage the Head-Assembly Lock
Pin:
1. Grasp the main handle and press down on
the head assembly.
2. While pressing the head down, pull out
the head-assembly lock pin. Release the
head-assembly lock pin, but maintain your
grip on the main handle. Slowly allow the
spring-loaded saw head to come up to
the top of its travel and then release the
handle.
22

TRANSPORTING AND MOUNTING

To avoid injury, follow
all statements identified
To avoid possible injury,
d i s c o n n e c t t h e p l u g
Never lift the tool by holding the switch
•
handle. This may cause serious damage to
the tool.
Never lift the miter saw by the power
•
cord. Attempting to lift or carry the tool by
the power cord will damage the insulation
and the wire connections, and possibly
result in electric shock or fire.
Place the saw on a firm, level surface
•
w h e r e t h e r e i s p l e n t y o f r o o m f o r
handling and properly supporting the
workpiece.
ONLY lift this saw by carry handles
defined in this manual
FIG. 14
3. While pressing the saw head down, push
in on the head-assembly lock pin. Release
the head assembly. The head will be
locked in the DOWN position.