skilsaw SPT88 Instrucciones De Funcionamiento página 30

5. Make sure that all controls are locked
before cutting.
WARNING
with operation. Before switching the tool on,
lower the head assembly on the saw to make
sure that the clamp clears the guard and the
head assembly.
Cutting Base Molding
Base molding can be cut vertically against fence or flat on the table.
•
Follow the table for helpful hints on cutting base molding
•
WARNING
proper saw operation and cause injury and/or tool damage.
If the saw head interferes with the workpiece while cutting it on the right side, it is
•
recommended to flip the workpiece and cut it to the left.
30
SAW OPERATIONS
Use a clamping position
that does not interfere
Check for interference between the workpiece and saw head components
by performing a dry-run simulation of the cut. Interference can prevent
6. Activate the switch. Lower the head
assembly and make your cut.
7. Wait until blade comes to a complete stop
before returning the head assembly to
the raised position and/or removing the
workpiece.
Fully closed positon
45° left