Transport; Mounting The Machine - Festool KAPEX KS 120 Manual De Instrucciones

Transport

Securing the machine (transport position)
– Press the on/off switch (3.1).
– Swivel the saw unit downwards until it reaches
the fence.
– Press the lock (3.2). The saw unit now remains
in the lower position.
– Tighten the rotary knob (3.3) to secure the saw
unit in the rear position.
4.5
4.4
– Wind up the mains cable into the cable holder
(4.5) before transporting.
– Stow away the Allen key (4.4) and the bevel (4.3)
in the holders provided.
Never carry or lift the machine by
the movable pivot guard (4.1). Carry the machine
by the edge of the saw table (4.2) and the handle
(4.5) in the cable holder.
Unlocking the machine (working position)
– Push the saw unit down slightly and remove the
transport safety device (3.2).
– Swivel the saw unit upwards.
– Unscrew the rotary knob (3.3).

Mounting the machine

socket before performing any type of work on the
machine.
Before using the machine, set up on a level, stable
work surface (e.g. Festool multifunction table MFT
or a workbench). The following assembly options
are available:
Fastening:
Secure the machine on the work surface using four
screws. Use the holes (5.1) on the four support
points on the saw table.
Clamps:
4.1
4.2
4.3
Secure the machine on the work surface using four
clamps. The fl at surfaces (6.1) on the four saw table
support points are used as clamping surfaces.
Clamping set (for MFT):
Secure the machine on the Festool multifunction
table MFT using the clamping set (494693) (7.2).
Use the two screw holes (7.1).
Always pull the plug out of the
7.2
11
5.1
6.1
7.1