Hydraulic System; Checking Hydraulic Oil Level; Changing Hydraulic Oil; Changing Hydraulic Oil Filter Element - Scag Power Equipment SWZU Manual Del Operador

HYDRAULIC SYSTEM

Checking Hydraulic Oil Level

The hydraulic oil level should be checked after the first 8
hours of operation. Thereafter, check the oil every 100
hours of machine operation or monthly, whichever occurs
first.
-IMPORTANT-
If the oil level is consistently low, check for leaks and
correct immediately.
1. Wipe dirt and contaminants from around the
reservoir cap. Remove the cap from the hydraulic oil
reservoir.
2. Visually check the level of hydraulic oil. Hydraulic oil
must be at least 2 inches from top of the filler neck.
If the level cannot be determined visually, use a clean
tape measure to check the level. If the fluid is low,
add 20W50 motor oil. DO NOT overfill; (overfilling
the oil reservoir may cause oil seepage around the
cap area).
3. Clean the fill cap and install it onto the reservoir.

Changing Hydraulic Oil

The hydraulic oil should be changed after every 500
hours or annually, whichever occurs first. The oil should
also be changed if the color of the fluid has become
black or milky. A black color and/or a rancid odor usually
indicates possible overheating of the oil, and a milky color
usually indicates water in the hydraulic oil.
-NOTE-
The hydraulic oil should be changed if you
notice the presence of water or a rancid odor
to the hydraulic oil.
1. Park the mower on a level surface and stop the
engine.
2. Place a suitable container under the hydraulic oil
drain. Remove the fill cap from the reservoir.
Remove the drain cap from the T-Fitting located on
the hydraulic system filter head. (See Figure 12).
Allow the fluid to drain into the container and
properly discard it.
Hydraulic Oil
Drain Cap
Figure 12. Hydraulic Oil Drain Cap
3. Reinstall the drain cap onto the T-Fitting and be sure
it is tight.
Before refilling the hydraulic oil reservoir the
hydraulic oil filter should be changed as well.
See instructions outlined below.
4. Fill the reservoir to 2 inches from the top of the filler
neck with 20W50 motor oil.
5. Replace the reservoir fill cap. Start the engine and
drive forward and backward for two minutes.
Check the oil level in the reservoir. If necessary, add
oil to the reservoir.

Changing Hydraulic Oil Filter Element

The hydraulic oil filter should be changed after every 500
hours of operation or annually, whichever occurs first.
1. Remove the oil filter element (Figure 12) and
properly discard it. Fill the new filter with clean oil
and install the filter. Hand tighten only.
16
Filter Head
Hydraulic Oil
Filter
2003SWZ-Oil Drain
-NOTE-