Acoustic Warning Signals; Service And Maintenance - Festool DWC 18-2500 Manual De Instrucciones


Remove the released button [19-1] with the
transport lever [19-3] and the spring [19-2]
from the slides (figure [19]).
19
19-3
WARNING
Any maintenance or repair work that requires
opening of the motor or gear housing should only
be carried out by an authorised Customer Service
Centre (name supplied by your dealer)!

Maintenance or repair work carried out by an
unauthorised person can lead to the wrong con-
nection of the power cord or other components,
which in turn can lead to accidents with serious
consequences.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festoolusa.com/ser-
vice
EKAT
4 Use only original Festool spare parts!
Order No. at: www.festoolusa.com/
5
3
2
service
1
18

Acoustic warning signals sound and the machine
switches off in the following operating states:
19-2
19-1

Service and maintenance

Observe the following instructions:
– Keep the air slits on the machine and the charger
free and clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
Information on battery packs
– Where possible, store the battery pack in a cool,
dry place at a temperature between 5 °C and 25
°C.
– Battery packs are most efficient at temperatures
between 20 °C and 30 °C.
– Protect the battery pack from moisture, water
and heat.
– Significantly shorter operating times after each
charge indicate that the battery pack is worn and
should be replaced with a new one.
– The LiIon battery pack is fully compatible with the
charger! Integrated electronics prevent over-
loading and overheating during the charging pro-
cess.
– Do not leave flat battery packs in a charger dis-
connected from the mains power supply for lon-
Clean individual parts, replace defective or worn
parts, and assemble in the opposite sequence.
During reassembly of the transport lever into
the slides, pay due care to correct fitting of
the spring [19-2] in the transport lever. In-
correct assembly may result in dysfunction
of the belt transport.

Acoustic warning signals

Battery flat or machine over-
loaded.
– Change the battery.
– Place the machine under reduced
stress.
Machine is overheating.
– You must allow the machine to
cool before using again.
LiIon battery pack is faulty or has
overheated.
– Once the battery pack has cooled,
perform a functional check using
the charger.