Maintenance
Caution on cleaning the unit
Do not use any
solvent (for example,
thinner, benzine,
etc.), detergent, or
insecticide. This may
damage the monitor or the unit.
Recommended cleaning method:
Gently wipe the panel with a soft, dry cloth.
How to clean the connector
Frequent detachment will deteriorate the connectors.
To minimize this possibility, periodically wipe the
connectors with a cotton
swab or cloth moistened
with alcohol, being
careful not to damage the
connectors.
Moisture condensation
Moisture may condense on the lens inside the unit in
the following cases:
• After starting the heater in the car.
• If it becomes very humid inside the car.
Should this occur, the unit may malfunction. In this
case, eject the disc and leave the unit turned on for a
few hours until the moisture evaporates.
How to handle discs
When removing a disc from its case, press down the
center holder of the case and lift the disc out, holding it
by the edges.
• Always hold the disc by the edges.
Do not touch its recording surface.
When storing a disc in its case,
gently insert the disc around the center
holder (with the printed surface facing
up).
• Make sure to store discs in their cases after use.
A dirty disc may not play correctly.
If a disc does become dirty, wipe it with
a soft cloth in a straight line from center
to edge.
• Do not use any solvents (for example, conventional
New discs may have some rough spots
around the inner and outer edges. If such
a disc is used, this unit may reject the disc.
To remove these rough spots, rub the
edges with a pencil or ball-point pen, etc.
Connectors
Center holder
To keep discs clean
record cleaner, spray, thinner, benzine, etc.) to clean
discs.
To play new discs
Do not use the following discs:
Single CD—8 cm (3-3/16")
disc
Sticker and sticker residue
Unusual shape
Transparent or semi-
transparent parts on its
recording area
REFERENCES
Warped disc
Stick-on label
C-thru Disc (semi-
transparent disc)
57