Ascaso Dream PID Manual Del Usuario página 25

NB! On completing the coffee
service, residual water will be released
through the discharge nozzle
Make sure that it is correctly placed
over the tray .
9
NB! It is normal for the ground
coffee in the filter holder
liquid consistency if the filter holder is
immediately removed
If pods or FAP-capsules are used:
Use the specific filter holder for
capsules or pods. Place the pod in
the filter holder (see figure 4). Follow
points 1, 2, 5, 6 and 7 as in the
previous section.
Pod (fixed filter holder)
Proceed as follows:
1. Follow Points 1 and 2, as in the
section for ground coffee.
2. Place a tablet on the filter holder
and turn it gently to the right as
far as it will go. Do not force it,
closure is smooth. (See figure 5).
3. Point 5, 6, 7 and notes as in the
previous section.
NB! Do not remove or turn the
filter holder while the water is running
through, as the machine is under
pressure at this time.
24 .
to have a
7
after delivery.
7
Figure 4
General tips:
1. The filter holder
be fitted in the machine
it warm. In the closed position.
2. If the coffee is not very hot when
made, increase the pre-set
temperature for coffee. See
section 6 of this manual.
3. Place the cups on the cup warmer
9 . Espresso is best at optimal
temperature (40°C/105°F) (see
figure 6).
4. The coffee will continue to drip out
for a few seconds after the coffee
is switched off.
Figure 6
NB! Tamping.
To obtain perfect espresso, the coffee
should be firmly tamped down.
NB! Pressure gauge:
In the PID versions, the temperature
is shown on the screen
for this purpose, with the working
pressure shown on the pressure
gauge on the front of the machine.
14
ascaso
Figure 5
should always
7
to keep
8
included
24
25