Storage, Transporting, & Mounting; Smart Guard System Storage; Rip Fence Storage; Miter Gauge Storage - skilsaw SPT70WT Instrucciones De Funcionamiento Y Seguridad

2610039875 12-15 E_SPT70WT 12/23/15 10:54 PM Page 17

SMART GUARD SYSTEM STORAGE

When not in use, the Main Barrier Guard and
Anti-Kickback Device can be stored under the
table.
Use of all the components of the Smart Guard
System, including Main Barrier Guard, Anti-Kick-
back Device, and Riving Knife is highly recom-
mended to provide protection against accidents
and injury.
1. Lock the Main Barrier Guard assembly into
place in the same manner as you would attach
it to the Riving Knife (Fig. 16).
2. Attach the Anti-Kickback Device to the hanging
bracket in the same manner that it attaches to
the Riving Knife (Fig. 17). For ease of installa-
tion; extend the table extension (fig. 42).

RIP FENCE STORAGE

When not in use, the rip fence can be stored
under the front right side of the table.
1. Turn rip fence upside down, then feed the end
of the fence into the railing (Fig. 18).
2. Slide the fence all the way in until the base of
the fence fastens to the clip.

MITER GAUGE STORAGE

When not in use, the miter gauge can be stored
under the right side of the table.
1. Insert the front end of the miter guide into the
slot located at the bottom of the push stick
holder (Fig. 19).
2. Snap the base end of the miter guide into the
clip located at the rear of the saw.
FIG. 18
Storage, Transporting, & Mounting
Clip Railing
3
-17-
FIG. 16
FIG. 17
FIG. 19