Adjusting Table Insert; Basic Table Saw Operation; Safety Power Switch - skilsaw SPT70WT Instrucciones De Funcionamiento Y Seguridad

2610039875 12-15 E_SPT70WT 12/23/15 10:55 PM Page 24
7. Insert folded paper between Riving Knife and
Fence.
A. Hold Riving Knife and paper firmly against
Fence (Fig. 36).
B. Lightly tighten the clamp screws.
C. Remove the paper - Slide fence away from
blade.
D. Slowly turn the Set Screw while watching the
Riving Knife tilt until it is in line with the blade.
E. Recheck squareness of riving knife to table
by sliding fence against blade. Readjust if
necessary.
8. After completing adjustments:
A. Lightly tighten hex nut (hold set screw posi-
tion with screwdriver while tightening nut).
B. Fully tighten Clamp Screws with Allen
wrench. Then fully tighten the hex nut.
NOTE: Check that the riving knife stays in line with
blade when the blade is tilted at any angle. Re-
place the Barrier Guard Assembly and Anti-Kick-
back Device before making cuts.
ADJUSTING THE TABLE INSERT
The table insert slot contains four (4) adjustment
screws for adjusting the height of the table insert
(Fig. 37). Place the insert onto the table. Place a
straight edge (such as the metal ruler from a com-
bination square) across the table top and insert
top – the surfaces should be at the same level. If
adjustment is necessary, use the included 2 mm
"L" wrench (packed with the table insert) to rotate
each set screw up or down.

SAFETY POWER SWITCH

NOTE: This table saw has a safety feature that
helps pre vent accidental starting.
To turn saw on: lift switch lever by pinching
side walls and pulling up. This action starts the
saw (Fig. 38).
To turn saw off: push switch lever down to its
original position (Fig. 38).
To prevent unauthorized use: the switch can ac-
commodate a padlock with a long 3/16" diameter
shackle (not included).
FIG. 36
Fence
FIG. 37

Basic Table Saw Operation

FIG. 38
-24-
Riving
Knife
Clamp
Screw
Table Insert
Screws
Paper